Easily Level or Elevate Your Shipping or Storage Container

STEP 1

Get the equipment needed to do the project successfully.

1. Leveling Leg

2. 20 Ton Hydraulic Jack (pictured) Not sold by us. You can use a 12 ton Hydraulic Jack.

3. 2”x6”x2’ Board

4. Level

5. Protective Eyewear

STEP 2

Clear the container hole of debris so that you can easily insert the leveling leg. Once cleared of debris , turn leveling leg on its side and insert into the hole on the side of your container. (Picture 1)

After inserting into your hole push leveling leg into the hole. (Picture 2)

STEP 3

While Leveling Leg is inserted into the hole, rotate the Leveling Leg 180 degrees.

STEP 4

Place Hydraulic Jack inside the Leveling Leg.

STEP 5

Place 2”X6”X2’ under the Hydraulic Jack. Make sure the Hydraulic Jack is lowered completely when placing under the Leveling Leg. Push Hydraulic Jack towards the container, to the back of the Leveling Leg .

STEP 6

Insert the Hydraulic Jack handle and start raising the Jack. Once the Hydraulic Jack is extended, make sure you get all the slack out of the Leveling Leg by pushing down on the top of the Leveling Leg once Hydraulic Jack is extended.

For Best Results

Start steps 1-6 on one side then repeat steps 1-6 on the other side. Then place a level in the middle of the container and jack each side until you are level. Once you get the container level, start jacking each side up the same number of times until you get it the height you want. Then place block under the contain-er near the leveling leg.